Connections; Configuration - Videotec TWM1 Manuel D'instructions

6 Connections

To make the connections just follow the arrangement given in the table below which, for each model,
shows the connector to be used according to the type of device to be connected.
Camera
Monitor
Twisted pair
Power supply
* In the TWRR1 receiver the connectors are on the back of the rack.

7 Configuration

The configuration procedure makes it possible to set up the unit for optimum performance and should
only be carried out by skilled, authorised personnel.
When configuring the TWT1A and TWRB1A models take particular care to prevent accidental contact
between the tool being used for regulation and the live parts (230V~), since the device must be powered when
carrying out the adjustments.
TRANSMITTERS
Active transmitter setup:
Set the dip switches to ON according to the distance of the cable in order to achieve the best video signal on
the monitor, (bear in mind that dip1 inserts the lowest equalisation and dip 3 the greatest; it is also possible to
set combinations of the 3 dip switches). Then, after adjusting the receiver, it may be necessary to change
slightly the settings made on the transmitter.
TWP TWM1 TWT1
BNC BNC
GND | IN
VIDEO
--- --- ---
A B A B A B
~
--- AC / DC
TWT1A
TWM1
MODEL
TWT1A TWRB1
---
GND | IN
VIDEO
--- GND | OUT
VIDEO
A B A B
L N AC / DC
TWP
Pag. 4
TWRR1* TWRB1A
---
OUT VIDEO GND | OUT
A B
POWER
SUPPLY
TWT1
MNVCTW_0610
---
VIDEO
A B
L N