Removal From Pool - Zodiac Pool Systems EN27 Serie Manuel Du Propriétaire

|
Robotic Pool Cleaner Owner's Manual

Removal from Pool

Depending on the model, you can manually
remove the cleaner from the pool or use the Lift
System feature.
For manual removal, pull gently on the floating
cable to bring the cleaner handle within arm's
reach.
Use the handle to lift the cleaner from the water
and hold the cleaner vertically over the pool
surface to drain (Figure 6). Never lift the cleaner
out of the pool by the floating cable.
Using the Lift System*
The Lift System is designed to assist in retrieving
the robot from the pool. Lift System can be
activated at any time during or after a cleaning
cycle.
1. Press any button to engage cleaner
controls.
2. Press
the automated procedure to bring the
cleaner to the wall.
NOTE: To stop the procedure at any time, press and
release the button again.
3. Next, Press and HOLD
cleaner.
4. Once the cleaner is facing the wall of your
choice for retrieval, release the button.
5. Cleaner will drive forward and up the wall
it is facing. It will wait at the waterline to be
retrieved.
on the control box to begin
to rotate the
6. When in reach, remove the cleaner from
the pool using the handle. The cleaner
will quickly expel water to allow for lighter,
easier removal (Figure 6).
NOTE: Never lift the cleaner out of the pool by the floating
cable.
*not available on all models
Figure 6. Always remove cleaner using the handle
9