Iaqualink Control; Iaqualink ® Control Home Screen; Set Cleaning Mode; Remote Control - Zodiac Pool Systems EN27 Serie Manuel Du Propriétaire

|
Robotic Pool Cleaner Owner's Manual
7
iAquaLink
Control
(connected models only)
Once you have downloaded the iAquaLink app and
connected the device to Wi-Fi, the iAquaLink app
allows for robotic cleaner control from anywhere,
anytime. Functions vary within the iAqualink app
depending on which cleaner model you have.
WARNING
Do not enter pool while the robotic cleaner
is in water.
®
iAquaLink Control Home Screen
App function and design is subject to change.
Start/Stop Cleaning
Remote*
Clean Mode
Lift System*
*not available on all models
®
Start / Stop Cleaning
The factory default cleaning surface setting is
Floor, Wall, Waterline.
1. From the Home screen or the Control Box
press the Start/Stop button to begin
cleaning.
2. The app displays the cycle time in hours
and minutes.
3. Press to interrupt and cancel an in-
progress cleaning cycle.

Set Cleaning Mode

1. From the home screen, select Cleaning
Mode to view and select.

Remote Control*

Use your mobile device as a remote control.
IMPORTANT: Only use Remote Control when in view of the
cleaner.
1. From the main screen, select the Remote
tab.
2. You can direct the cleaner using the remote
control to help pick up debris.
NOTE: If you experience significant delays between the
app command and cleaner response, you may
have a weak Wi-Fi signal or other connectivity
challenges that interfere with the immediacy of
the remote control functions.
*not available on all models
15