Maintenance; Cord Tangling - Zodiac Pool Systems EN27 Serie Manuel Du Propriétaire

10
5

Maintenance

WARNING
To avoid electric shock and other hazards which
could result in permanent injury or death,
disconnect (unplug) the cleaner from the power
source before performing any cleaning and
maintenance.

Cord Tangling

Tangling can occur more frequently when the
cleaner is not attended to after each cleaning
cycle. Proper installation, general maintenance
and the following troubleshooting steps can help
to avoid cable challenges.
IMPORTANT
Cleaner power cable may become tangled if
correct procedure is not followed after each
cleaning cycle.
NOTE: Place all of the floating cable in the water to allow
free movement in your pool from the central point.
Spread out the floating cable ensuring there are no
kinks or coils in the cable (Figure 7).
cleaner
cleaner
Figure 7. Optimal Entry Point in Pool
Not
Recommended
caddy /
control unit
Recommended
entry point
WARNING: Do not use
an extension cord
If tangling occurs, follow these steps:
1. Remove the cleaner from the pool. When
the cleaner is within arm's reach, use the
handle to remove from the water. Never lift
the cleaner out of the pool by the floating
cable.
2. Hold the cleaner vertically to drain
(Figure 8).
Figure 8. Keep Cleaner Vertical to Drain Water
3. Unplug power to the cleaner at the control
box (Figure 9).
Figure 9. Unplug
|
Robotic Pool Cleaner Owner's Manual