Table des Matières
Publicité
Step 8
Carefully turn your unit over onto its front edges.
å
Tighten the TWIST-LOCK® FASTENERS in the FRONT
å
PANEL (G) at this time.
NOTE: The BACK is reversible.
å
A perforation in the BACK (I) has been provided for access
å
to the SAFETY STRAP (60M). Unfold the BACK and punch
out the perforation and push the SAFETY STRAP through
the hole.
Make equal margins along the two long edges of the
å
BACK (I). The bottom edge of the BACK (I) and bottom
surface of the BOTTOM (F) should be even. Push on
opposite corners of your unit if needed to make it "square".
Fasten the BACK (I) to your unit using the NAILS (5N).
å
NOTE: Be sure to tap NAILS into the holes that line up
å
over the SHELVES (D and E).
Fasten the HINGES (16H) to the BOTTOM (F) and FRONT
å
PANEL (G). Use eight BLACK 9/16" LARGE
HEAD SCREWS (1S).
Tighten the
TWIST-LOCK®
FASTENERS in
FRONT PANEL.
16H
Page 12
F
G
These holes must line up
over the SHELVES (D and E).
I
BLACK 9/16" LARGE HEAD SCREW
(8 used for the HINGES)
422600
Caution
Do not stand the unit upright
without the BACK fastened. The
unit may collapse.
Before fastening the
BACK, punch out the
perforation and push
the SAFETY STRAP
through the hole.
60M
NAIL
(58 used in this step)
1S
www.sauder.com/services
5N
Publicité
Table des Matières
