Trouble Shooting - Grizzly Tools ERM 1846 GT Traduction De La Notice D'utilisation Originale

Trouble Shooting

Problem
Equipment does
not start
Motor stops
Result unsatis-
factory or motor
labours
Blade fails to turn
Strange noises, rat-
tling or vibrations
Possible Cause
Power is off
Defective start lever (
or release button (
Worn carbon brushes
Defective motor
Grass too long
Blockage by foreign object Remove the foreign object
Cut height too low
Blade ( 25) blunt
Blade area blocked
Blade ( 25) assembled
incorrectly
Blade ( 25) blocked by
grass
26) loose Tighten the blade screw
Blade screw (
26) loose Tighten the blade screw
Blade screw (
Blade ( 25) damaged
Fault Fixing
Check the socket, cable, wire and
plug and have any repairs carried
out by an electrician
2)
19)
Repair by customer services
Set a greater cut height. Lift the front
wheels slightly by pressing down on
the handle bar.
Set a higher cut height
Have the blade sharpened or re-
place it
Clean the equipment
Install the blade correctly
Remove the grass
Replace the blade
GB
79