Maintenance And Storage - Protemp PT-16-TTC Manuel De L'utilisateur Et Mode D'emploi

Lighting Instructions (cont.)
9. Once lit, keep the plunger depressed for thirty
(30) seconds. Then release the plunger, and
if the burner stays lit, remove and extinguish
the match. You will know that the burner is lit
when the mesh screen begins to glow red.
10. If the burner does not stay lit, repeat the
lighting process. If the heater does not light
after several attempts, be sure you are getting
fuel to the burner. The faint smell of gas will
tell you if the fuel is flowing. If not, there may
be a problem with your LP cylinder. Take it
back to your local dealer for replacement.
11. Once the burner is lit, turn Regulator Control
Knob to desired setting
12. Light all burners when maximum heat is
desired. Follow Lighting Instructions steps
1-11. The second and third burner should be
lit separately. Do Not Attempt to light second
burner off the first burner. Be sure NOT to
point burners at one another.
1. Inspect your heater before each use. Check all
connections for leaks, following the procedure
outlined on Page 9. Check the Regulator Hose
(dual burner models only) for any cracks,
breaks or wear. If the hose is damaged replace
it with the correct manufacturers part. Heater
should be inspected before each use and once
annually by a qualified service person.
© 2018 Pinnacle Climate Technologies, Inc.
®
OPERATION (CONT.)
(HI) / (MED) / (LO ).

MAINTENANCE AND STORAGE

NEVER LEAVE HEATER UNATTENDED WHILE
BURNING OR WHILE CONNECTED TO A FUEL
To Turn Off Heater:
1. Turn the valve on the LP cylinder CLOCKWISE to
stop the flow of fuel.
2. Turn the heater regulator knob to the
position and wait at least fifteen (15) minutes for
the heater to cool.
3. Tightly close the gas shutoff valve on the LP
cylinder after each use.
4. Remove the heater from the LP cylinder by
reversing the steps in Connecting Heater to
LP Cylinder on Page 9. DO NOT store the LP
cylinder with the heater still attached or in an
enclosed area.
NOTE: ALWAYS INSPECT HEATER BEFORE USE
AND AT LEAST ANNUALLY BY A QUALIFIED
SERVICE PERSON.
DANGER
metal components while in operation. Keep
gasoline­and­any­other­flammable­liquids­away­
from the heater.
DANGER
CAUTION
tube.
2. After use, always disconnect the heater
from the LP cylinder, and store the heater
separately from the tank. Be sure to close
the tank valve after use, and before storage.
The LP cylinder should be stored outdoors in
accordance with chapter 5 of the Standard for
Storage and Handling of Liquefied Petroleum
Gases (ANSI/INFPA 58).
Propane Tank Top Heater User's Manual
12
SOURCE
EXTREMELY HOT during
operation. Do Not touch any
Never bring or store a propane
cylinder indoors.
DO NOT insert the lit match into
the air inlet holes in the mixing
(OFF)