Unpacking; Assembly - Protemp PT-80V-LPC Manuel De L'utilisateur Et Mode D'emploi

1. Remove all packing items applied to heater for
shipment. Keep plastic cover caps attached to
inlet connector and hose / regulator assembly
for storage.
2. Remove all items from carton.
Attaching The Upper Housing
• Tools Required: Phillips Screwdriver
1. Slide Upper Housing straight up and off of
lower housing and remove all packed items
from inside the heater (See Figure 2).
2. Remove all packaging protecting the heater
during shipping. Retain caps for covering the
inlet connector and regulator hose fro storage.
3. Attach three (3) screws to the bottom row of
holes in the lower housing (See Figure 3).
Figure 2
© 2018 Pinnacle Climate Technologies, Inc.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING,
CONNECTED TO A POWER SOURCE, OR WHILE CONNECTED
®

UNPACKING

ASSEMBLY

TO A FUEL SOURCE
The Propane (LP) gas pressure
CAUTION
regulator and hose assembly
supplied with the heater must be used without
alteration.
4. Slide upper housing over lower housing, lining
up the four remaining screw holes. Insert three
(3) screws and tighten securely (See Figure 3).
NOTE: Save carton and packaging material for
later storage.
Figure 3
6
Convection Heater User's Manual