Publicité
Les langues disponibles
Les langues disponibles
13. Lap belt guides (x2 - for rearward facing use only)
14. Seat reclining lock
Adjusting the harnesses
Make sure that the harness of your car seat is adapted to the height of your child be-
fore starting to install the seat in your car. The harnesses can be adjusted to 4 different
heights and must be positioned as close as possible to your child's shoulders (2).
•
The two lower positions are ONLY intended for use in group 0, for a child weighing from 0 to
10 kg in a rear-facing position. If your child's shoulders are between two levels in a rear-facing
configuration, choose the lower of the two.
•
The two upper positions are ONLY intended for use in group 1, for a child weighing from 9 to
18 kg in a front-facing position. If your child's shoulders are between two levels in front-facing
configuration, choose the higher of the two.
To adjust the height of the harnesses, remove the upper section of one of the harness straps
by pivoting the metal anchor located behind the back rest and then pulling it through the
slots of the shell and cover (3). Repeat the operation on the upper section of the second strap.
Feed the ends of the harness straps through the slots at identical level in both the cover and
the shell, according to the chosen configuration:
•
For a rear-facing configuration (Gr. 0, from 0 to 10 kg), the harnesses are fed through one
of the two lower positions and then up to the third position to be secured inside the shell
(5). Make sure that the metal anchor is correctly positioned and that the ends of the harness
straps are not twisted.
IMPORTANT: Whichever of the two lower positions you have chosen, make sure that the met-
al anchors of the harnesses are well secured through the slots of the third position of the shell.
•
For a front-facing position (Gr. 1, from 9 to 18 kg), the harnesses are fed through one of
the two upper positions and are secured directly behind the position chosen, at the back of the
shell
(6)
(7). Make sure that the metal anchor is correctly positioned and that the ends of the
harness straps are not twisted.
The correct type of safety belt to use with your car seat
Your car seat must ONLY be installed on a passenger seat fitted with a 3-point safety belt.
NEVER install your car seat on a passenger seat fitted with a 2-point safety belt!
kg) (i - 9-25kg)
Rearward facing use (Gr.0 // 0 - 10 kg)
DO NOT USE THIS CHILD SEAT ON A PASSENGER SEAT FITTED WITH AN AIR BAG!
When used rearward facing, the child seat must be in the fully reclined position.
and diagonal sections of the car seat belt until fully extended and feed both through the space
between the shell and the base. Fasten the seat belt.
Thread the lap section through the guides located at the front of the base (8).
Thread the diagonal strap through the two upper guides located on the back of the seat shell
(9).
Tighten the seat belt by pulling first on the lap section, then on the diagonal one (10). Check
that there are no kinks or twists in the seat belt.
Lock the 2 sections of the belt with the blue lock-off clip. The lock-off should be positionned
(i - 0-10
Pull lap
31
User guide - EN
(4)
Publicité
