Installation Instructions; Care And Maintenance - Climadiff VSV12F Manuel D'utilisation

4. INSTALLATION INSTRUCTIONS

Before using your appliance
 Remove the inner and outer packaging.
 Allow the appliance to rest for two hours before switching it on.
 Clean the inside using a soft cloth and lukewarm water.
Using your temperature control cellar
The appliance must be positioned in a room with an ideal ambient temperature of 25°C.
If the ambient temperature is higher or lower, the appliance's performance may be affected.
Installing your appliance
 This appliance is designed for free-standing installation.
 Position it in a place with sufficient strength to support its weight when loaded. To ensure that it is
level, adjust the height of the feet underneath.
 To get the best from your appliance with the lowest energy consumption, do not place the
appliance close to a heat source (heater, cooker, etc.), do not expose it to direct sunlight, and do
not place it in a room which is too cold.
 Connect the appliance to a single socket, leaving a 30 mm gap between the back of it and the wall
and 2 cm on each side. Be careful to support it, so that it is perfectly level (use of a spirit level is
recommended). This will prevent any movement due to instability, causing noise and vibration, and
will ensure that the door seals perfectly.
Selecting the temperature
You can choose the desired temperature in the compartment, using the
temperature selected increases/decreases by 1°C with each button press.
This appliance belongs to category 10 according to the European regulation N°1060/2010. The
temperature setting is from 14° to 18°C. However, the appliance's technical performances allow to
reach a wider temperature range from 12° to 18°C.
The interior light may be switched on or off using the

5. CARE AND MAINTENANCE

Before cleaning your appliance (something that should be done regularly), disconnect it by removing
the plug or by pulling the fuse on the circuit.
Before using your appliance for the first time and regularly after that, we recommend that you clean
the inside and outside (front, side and top) with warm mixed with a gentle cleaning product. Rinse with
clean water and allow drying before reconnecting. Do not use solvents or abrasives.
When the appliance is switched on for the first time, there may be a residual odor. In that case, runt
the appliance empty for a few hours at the coldest possible temperature. The cold will kill any odors.
In case of a power cut
Most power cuts are resolved within a short time. A power cut of 1 or 2 hours will not affect the
/
button.
buttons. The
24