Publicité
Les langues disponibles
Les langues disponibles
MOUNTING
1. Disassemble the diffuser and LED panel.
2a. Cable via rear entry: Thread the connecting cable through the thule and fix with the strain relief.
2b. Cable via side entry: Place a PG13.5 cable gland in the breakout port. Feed the connecting cable through the cable gland
and fix with the strain relief. Then tighten the swivel.
3. Fix the fixture on the surface with screws.
4. Connect the power cord on the terminal correctly.
5. Assemble the LED panel and diffuser.
Mounting
2a
Cable rear entry
4
Cable connection
MAINS POWER
Remove in Master/Slave use
Without sensor
12
1 5
2b
Cable side entry
MAINS POWER
With sensor
(switched phase not required)
www.prolumia.eu
PG13.5
Publicité
