Cleaning And Maintenance - Klarstein PURISTA Mode D'emploi

CLEANING AND MAINTENANCE

Cleaning the filter grid.
• Remove the grid as shown in the picture below.
• Method 1: Place the grid in warm water of 40-50 °C for 3 minutes. Add a
detergent and let the grid soak for 2-3 minutes. It is best to put on gloves and
clean the grille with a soft brush. Do not apply too much pressure, as the grid
is delicate and can be easily damaged.
• Method 2: Place the filter grid in a dishwasher. Set the temperature to 60 °C.
• Do not use abrasive cleaners, as they will damage the hood.
• Make sure the unit is turned off when you clean it.
Replacing the bulb
• Make sure that the appliance is not under power (switch off via the fuse )
before replacing the bulb.
• Push the handle of the aluminum filter towards the rear housing until the
filter comes out of the housing. Remove the filter by pushing it down.
• Change the bulb. Use one of the 28 W / E14 type. Put the filter back on.
EN
23