EN Safety
PL Bezpieczeństwo
• Do not use this appliance to reheat food in heat-
retaining bags intended for normal ovens, such as
roasting bags. Such heat-retaining bags usually contain
a thin layer of aluminium foil that reflects microwaves.
This reflected energy could, in turn, cause the outer
paper covering to become so hot that it ignites.
EN
Installation
All installation must be carried out by a competent
person or qualified electrician. Before connecting the
mains supply ensure that the mains voltage corresponds
to the voltage on the rating plate.
Direct Connection
The appliance must be connected directly to the mains
using an omnipolar circuit breaker with a minimum
opening of 3 mm between the contacts.
The installer must ensure that the correct electrical
connection has been made and that it complies with the
wiring diagram.
The cable must not be bent or compressed.
Regularly check the power cord for damage. If the
supply cord becomes damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
WARNING: This is a Class I appliance and MUST
be earthed.
The appliance is supplied with a 3-core mains cable and
must be connected to the electricity supply via a double
pole switch having a 3 mm minimum contact gap on each
connector.
The Residual Current Device (RCD) must be rated at
16 Amps.
The wires in the mains lead are coloured in accordance
with the following code:
Brown = L - Live
Blue = N - Neutral
Green and Yellow =
- Earth
EUR
N
N
L
L
(Blue)
N
L
(Brown)
(Green/Yellow)
FR Sécurité
RO Siguranță
UK
DOUBLE POLE SWITCHED
FUSED SPUR OUTLET
FUSE ON
USE A 16AMP FUSE
To avoid the risks that are always present when you
use an electrical appliance it is important that this
appliance is installed correctly and that you read the
safety instructions carefully to avoid misuse and hazards.
Please keep this instruction booklet for future reference
and pass it on to any future owners. After unpacking the
appliance please check that it is not damaged. If in doubt,
do not use the appliance but contact Customer Services
- see end of Care & Maintenance section for details.
EN
Technical data
This is a Group 2 Class B appliance.
This appliance is Group 2 as it intentionally generates
radio-frequency energy for heating food and drink.
This appliance is Class B as it is suitable for use in
residential environments and establishments directly
connected to a low voltage power supply network which
supplies buildings used for domestic purposes.
Voltage input
Maximum Power
Rated power output – Microwave
Rated Current
Oven Capacity
External Dimensions
(without handle)
Weight
Instructions de contrôle
FR
Ces consignes concernent votre sécurité. Lire
attentivement les instructions suivantes et les sections
« Installation, entretien et maintenance » avant de
procéder à l'installation et d'utiliser cet appareil.
Conserver les notices pour référence ultérieure.
AVERTISSEMENT : toutes les installations doivent être
effectuées par une personne dûment qualifiée, en
suivant rigoureusement les réglementations locales en
matière de construction et les présentes instructions.
• Afin d'éviter les risques toujours présents lors de
l'utilisation d'un appareil électrique, il est important
d'installer correctement ce four et de lire les
instructions de sécurité soigneusement en vue
d'empêcher tout danger ou toute mauvaise utilisation.
Après avoir retiré l'emballage du four, vérifier qu'il
n'est pas endommagé. En cas de doute, ne pas utiliser
l'appareil et contacter le service client au 0800 733 030
france@kingfisherservice.com.
• Contrôler l'emballage et s'assurer de disposer de
toutes les pièces énumérées, puis décider du bon
emplacement du produit.
• Si ce produit comporte du verre, rester prudent lors
du montage ou de la manipulation pour éviter toute
blessure ou l'endommagement du produit.
04
230V~ 50Hz
3200 W
800 W
14 A
71 L
595 x 565 x 454 mm
45 kg