Lanaform Stim+ Instructions page 9

TROUBLESHOOTING
Breakdown
Low stimulation or the user feels
prickling
The appliance stops its cycle before
the end
The skin treated becomes red,
itches or prickles
Even at maximum intensity, the
stimulation is too weak or the user
lacks any sensation
The electrodes do not stick
anymore
ADVICE REGARDING THE DISPOSAL OF WASTE
• All the packaging is composed of materials that pose no hazard for the environment and which
can be disposed of at your local sorting centre to be used as secondary raw materials. The
cardboard may be disposed of in a paper recycling bin. The packaging film must be taken to
your local sorting and recycling centre.
• When you have finished using the device, please dispose of it in an environmentally friendly
way and in accordance with the law.
Checks
Check that the electrode is in
contact with the skin
Check that the surface of the
adhesive disk is not dirty
Check that no grease is present
on your skin
Check that the battery is charged
Check that you are not allergic to
the adhesive disk
Is your skin dirty?
Are the electrodes positioned
correctly?
Solutions
Position the adhesive disk of the
electrode firmly on the skin
Clean or replace the adhesive disk
Clean your skin
Charge the Stim+
Check your allergy record for your
skin. If your allergic reaction is
minor, simply change the position
of the adhesive disk or shorten the
duration of the treatment. If your
allergic reaction is severe, cease all
use of the appliance or use anti-
allergy medication
Re-use the appliance after cleaning
your skin with a wet flannel
Dip them in water for a few
seconds
Stim +
EN
9