Meaning Of The Characters Shown On The Display Card - FAS International 480 ELE Mode D'emploi

12
7.2 MEANING OF THE CHARACTERS SHOWN ON THE DISPLAY CARD fig. 4
CHARACTER
0 =
1 =
2 =
3 =
4 =
5 =
6 =
7 =
8 =
9 =
A =
a =
b =
C =
c =
d =
E =
F =
P =
- =
EXPLANATION OF THE MEANING OF THE CHARACTERS OF THE TABLE
CHARACTER "1"
Character "1" appears when the control card is not able to communicate with the coin mechanism.
Control that the DIP-SWITCH DSW1 is correctly set. Otherwise:
1) Check that the coin mechanism has been correctly programmed.
2) Check the connection between the connector JP11 of the card and the coin mechanism.
CHARACTER "4"
Character "4" appears when the thermic relay of the column engine has tripped due to an over-
heating of the engine itself.
Attract by hand all the small solenoid magnets and check that the column rotates freely.
Otherwise:
1) Check the connection between the connector JP1 of the card and the thermic relay 1.
CHARACTER "5" (only in the vending machines BO and FAS-DUO)
Character "5" appears when the thermic relay of the engine for the withdrawal of bottles/cans has
tripped due to an over-heating of the engine itself.
Control that the withdrawal engine is not blocked.
Otherwise:
1) Check the connection between the connector JP1 of the card and the thermic relay 2.
CHARACTER "7"
Character "7" appears when the micro-switch of the delivery door is not pressed (the delivery door
has remained open).
Check that the delivery door closes correctly.
Otherwise:
1) Check the connection between the connector JP6 of the card and the micro-switch of the
delivery door.
2) Check the integrity of the micro-switch of the delivery door.
FAS INTERNATIONAL srl
MEANING
NOT USED
INTERR. IN THE COMMUNICATIONS WITH THE COIN MECHANISM
NOT USED
FREE SALE (NOT CONTROLLED)
THERMIC RELAY ENGINE COLUMN 1 TRIPPED
THERMIC RELAY ENGINE COLUMN 2 TRIPPED (BO-FAS_DUO)
RELOAD CYCLE RUNNING
MICROSWITCH DELIVERY DOOR NOT AT REST
COIN MECHANISM INHIBITED (NOT CONTROLLED)
SOLENOIDS NOT AT REST OR MICROSWITCH SERIES NOT OK
INTERRUPTED OR FAULTY POTENTIOMETER
SEL. BUTTON X ALWAYS PRESSED (NOT CONTROLLED)
MICROSWITCH OR SOLENOID OF THE LOCK NOT OK
DEFROST CYCLE RUNNING
INTERRUPTED OR FAULTY PROBE
SOLENOID X DOES NOT BE ATTRACTED (TX failure vend)
CYCLE OF SELF-TEST RUNNING
START PROGRAM EXECUTION (ONLY AT RESET)
ERROR SOFTWARE
NORMAL FUNCTIONING
Downloaded from www.vendingbar.gr