Connecting The Can Bus Interface - Dometic MagicSpeed CBI150 Instructions De Montage Et De Service

Connecting the CAN bus interface

7 Connecting the CAN bus interface
I
NOTE
The configuration of the OBD-II plug can be found in fig. 6.
Supplementary to fig. 5
➤ Before installation, make sure that the output signals you need for your vehicle are available
from CBI150.
You can find a detailed vehicle list at:
http://www.dometic.de/product/waeco-magicspeed-cbi-150
I
NOTE
Only connect the cables to the CAN bus cables in the vehicle which are specified in the
vehicle list.
➤ Connect the white and the blue cables with the CAN bus cables as described in the vehicle
list.
➤ Insert the plug of the connection cable into the socket of the CAN bus interface.
➤ Switch on the ignition.
✓ The status LED indicates the system status.
Status LED flashes: the vehicle type has been recognised
You can use the CAN bus interface.
You can test the functions as follows:
➤ Switch the ignition and all the consumer units off.
➤ Remove the ignition key.
➤ Close and lock all the vehicle doors.
✓ The status LED goes out after a delay time (depending on the model).
Status LED is lit: the vehicle type is not recognised
➤ Check whether:
– the vehicle type is included in the vehicle list.
– the CAN bus cables are correctly connected.
– the CAN bus cables are detected in the right position in the vehicle (see vehicle list)
Status LED is switched off
➤ Check whether:
– the power supply is 12 V
– the CAN bus cables are correctly connected.
6
CBI150
EN