Charging; Lens Barrel (Speed Focus); Turning On And Off; Cleaning - Kulzer signum HiLite pre 2 Mode D'emploi

– Do not short the ends of the battery – risk of burning and fire!
– The battery of the HiLite pre 2 is not charged when it is delivered.
To replace the battery, switch off the HiLite pre 2 and then unscrew the cap at the end. Take out the used battery
and dispose of it correctly. Insert the new battery with the positive pole (+) first. Close the HiLite pre 2 by screwing the
end cap back in place.
7.2

Charging

Turn off the HiLite pre 2 during charging. Then connect the HiLite pre 2 with the magnetic charging clip and connect it
via the appropriate cable to the USB port of the power supply. Then plug the adapter into an electricity outlet.
Charging indication light:
Red (steady) – charging.
Green (steady) – fully charged, HiLite pre 2 is ready for operation.
Green (blinking) – measuring procedure, pre-charging (after total discharge of the battery or if not used for a long time)
can take up to 300 seconds.
Red (blinking) – indicates an error (e.g. short circuit, check if the battery insert into the battery compartment
is correct).
7.3

Lens barrel (Speed Focus)

The HiLite pre 2 can be focused using the " Speed Focus " function. To adjust the beam simply push the head
of the HiLite pre 2 forwards or backwards with your thumb.
7.4

Turning ON and OFF

To turn HiLite pre 2 ON and OFF, push the button at the end of the hand piece to achieve maximum light output
The " Micro Controller Switch System " uses a micro-processor to control the illumination of the LED.
The HiLite pre 2 has three settings: Power Light , Low Power Light and Strobe Light .
Power Light (recommended!):
Push the button at the end of the HiLite pre 2 for continuous light or simply touch it for instant light.
Low Power Light:
Touch the button at the end of the HiLite pre 2 once and then switch on fully within 1 second.
Strobe Light:
Touch the button at the end of the HiLite pre 2 twice and then switch on fully within 1 second.
NOTE
The 'reduced brightness' and 'strobe light' functions will be activated only once for the process that is running
and deactivated after switching off. When the following process starts, it will automatically reset to 'maximum
brightness'.
8

Cleaning

CAUTION
Clean the unit completely with a slightly moistened cloth, making sure that no fluid gets into the housing of the
unit. There is a risk of damage due to short circuit. Do not use abrasive detergents (scouring powder, solvents, etc.).
NOTE
The handpiece contacts must always be cleaned separately after cleaning the housing. Contact surfaces that
are soiled or have become wet from cleaning or disinfectant agents may affect the charging. Clean or dry the
contact surfaces with a lint­free cloth or cotton bud slightly moistened with a cleaning agent containing alcohol.
GB
- 5 -