Medaxis debritom Mode D'emploi page 43

Electromagnetic compatibility (EMC, IEC 60601-1-2:2007, Table 6)
Recommended separation distance between portable and mobile
RF communications equipment and the debritom
+
The debritom is intended for use in an electromagnetic environment in which radiated RF disturbances
are controlled. The customer or the user of the debritom
by maintaining a minimum distance between portable and mobile RF communications equipment
(transmitters) and the debritom
the communications equipment.
Rated maximum
output
Power of transmitter
W
0,01
0,1
1
10
100
For transmitters rated at a maximum output power not listed above, the recommended separation
distance D in meters (m)
can be estimated using the equation applicable to the frequency of the transmitter, where P is the
maximum output power rating of the transmitter in watts (W) according to the transmitter manufac-
turer.
NOTE 1: At 80 MHz and 800MHz, the higher frequency range applies.
NOTE 2: These guidelines may not apply in all situations. Electromagnetic propagation is affected by
absorption and reflection from structures, objects and people.
RF Transmitter/Reciver used in the equipment
Bluetooth 4.0 (single mode/Bluetooth smart): max RFoutput power 3.2mW 2.402-2.480 GHz, ISM
band.
RFID 13.56MHz
Service:
Requirements for service personnel: The service personnel must be trained by Medaxis AG in order
to service the debritom
Medaxis AG will make available on request circuit diagrams, component part lists, descriptions,
calibration instructions, or other information for Medaxis authorised service centres.
+ as recommended below, according to the maximum output power of
Separation distance according to frequency of transmitter m
150 kHz to 80 MHz
D = (1.17)√P
0,117
0,369
1,17
3,69
11,7
+
and its accessories.
+
.
+ can help prevent electromagnetic interference
80 MHz to 800 MHz
D = (1.17)√P
0,117
0,369
1,17
3,69
11,7
Mode d'emploi de Medaxis debritom
800 MHz to 2.5 GHz
D = (2.33)√P
0,233
0,738
2,33
7,38
23,3
+
41