Plc Messages; Status Messages; Nederman Flexpak Off (Off Mode); Nederman Flexpak Standby (Standby Mode) - Nederman FlexVAC Manuel De L'utilisateur

6 PLC messages
The following sections show the different status, warning and alarm messages that can be seen in the PLC dis-
play. See also the PLC Settings Manual and the Installation and Service Manual.
If a message is displayed that is not shown in this user manual, see the PLC Settings Manual for more in-
formation.
If a warning or alarm is displayed that is not shown in this user manual, see the PLC Settings Manual for
more information and contact a Nederman authorized service technician.
6.1 Status messages
The following status messages give information about what mode the unit is in or what routine service is being
performed.
6.1.1 Nederman FlexPAK Off (Off mode)
The unit is in Off mode, which is also the unit's start menu. The unit can also go into Off mode if something is
wrong, such as if an alarm is activated. The pump motor is off, there is no vacuum, the FCV is closed, and the unit
cannot be activated by a pilot signal.
FlexPak
Hi Vacuum Unit
OFF
Time To Service
2000 hours
6.1.2 Nederman FlexPAK Standby (Standby mode)
The unit is in Standby mode. The pump motor is off, there is no vacuum, the FCV is closed, and the unit is waiting
for a pilot signal to go into Running mode.
NEDERMAN
FLEXPAK
Standby
Wai ng For
Pilot Signal
Mo 15:33
FlexVAC
TimeToService: The amount of time until the next
scheduled service. The default setting is 2000 hours.
ESC OK
ESC OK
EN
19