Publicité
Les langues disponibles
Les langues disponibles
CARE AND MAINTENANCE
․ ALWAYS disconnect the power cord from the electrical outlet before any internal
maintenance or replacement of parts is done.
․ Dust the table on a regular basis using a soft, lint-free cloth and a high-quality furniture
polish. Always avoid "dry dusting" the table as dusters can scratch the wood finish.
․ Always use the same type of furniture polish when dusting the table. Alternating
between different types of furniture polish can cause clouding of the wood finish.
․ Avoid using soap/water to clean the table. Soap can damage the wood finish and water
can penetrate the wood causing damage. Anytime liquid comes into contact with the
table, it should be dried immediately to avoid damage to the wood.
․ If possible, the table should be placed in a location where it will not be exposed to direct
sunlight for long periods of time. Sunlight can cause damage to wood finishes, so
minimizing its exposure will lengthen the life of the table.
․ Use caution when opening the metal cabinet of the pop up power outlet during inspection
and maintenance.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and the receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
Warning: changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment
This Class B digital apparatus complies with Canadian ICES-003(B).
IC STATEMENT This device complies with Industry Canada's license-exempt RSSs. Operation is
subject to the following two conditions: (1) This device may not cause interference; and (2) This
device must accept any interference, including interference that may cause undesired operation of
the device.
SAVE THESE INSTRUCTIONS
5
Publicité
