Publicité
Les langues disponibles
Les langues disponibles
• If you are uncertain that product is properly installed, call customer care.
Note: There are fi ve mounting positions. The
2
center position is shown (right). Slide washer
(J) over wall support arm axle (D). Next, insert
plastic cap (N) into axle. Then, insert holding pin
(M) into axle. See detail 1.
Place arm assembly (C) with washer (J) into wall
2-1
plate (A). Insert axle assembly shown in detail
1 through wall plate (A), arm assembly (C), and
washer (J). Lock axle in place by aligning hold-
ing pin (M) with notches shown in detail 2.
Insert socket cap screw (K) into hole at bottom
2-2
of wall support arm axle (D) as shown in detail 3.
Tighten screw using 9/64" allen wrench (Q).
Note: Fit of axle (D) into wall plate (A) and arm
assembly (C) will be tight. Gently tap into place
with a hammer if necessary.
Snap four cable management clips (R) into top or bottom of arm assembly (C) as shown. Cable ties (S) are used
3
with clips for cord management.
Slide one mesh sleeve (T) over each cable. Use cable ties (S) to tighten mesh sleeves to cables.
3-1
WARNING
R
C
S
7 of 41
N
J
D
M
A
C
J
K
ISSUED: 06-05-06 SHEET #: 202-9141-9 04-30-11
DETAIL 1
DETAIL 2
D
DETAIL 3
T
NOTCH
Publicité
