peerless-AV PLA60-UNL Installation Et Montage page 11

For Flat Back Display
Begin with the shortest length screw, hand thread through multi-washer and adapter bracket into display as
7-1
shown below. Screw must make at least three full turns into the mounting hole and ¿ t snug into place. Do not
over tighten. If screw cannot make three full turns into the display, select a longer length screw from the bafÀ ed
fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
NOTE: Spacers may not be used, depending upon the type of display.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
For Bump-out or Recessed Back Display
Begin with longer length screw, hand thread through multi-washer, adapter bracket and spacer in that order into
7-2
display as shown below. Screw must make at least three full turns into the mounting hole and ¿ t snug into place.
Do not over tighten. If screw cannot make three full turns into the display, select a longer length screw from the
bafÀ ed fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
DISPLAY
ADAPTER
BRACKET
(BB)
DISPLAY
SPACER
11 of 41
fi g. 7.1
MULTI-WASHER
SCREW
fi g. 7.2
MULTI-WASHER
SCREW
ADAPTER
BRACKET
(BB)
ISSUED: 06-05-06 SHEET #: 202-9141-9 04-30-11