Publicité
Les langues disponibles
Les langues disponibles
3) Check the compatibility of the wheel (6) and
flange, no clearance is allowed. Then tighten
the outer flange (7) with the spanner (8).
4) Unplug the spanner (8) and loosen the spindle
lock button (1).
5. SWITCH ON AND OFF
WARNING: To reduce the risk of injury, to
make sure you can control the switch freely and
keep it off before plugging grinder.
The switch includes the lock button a and the
trigger b. The lock button must be pressed to
activate the trigger, which will avoid accidental
starting the machine.
1) ON: Push the lock button and depress the
trigger.
2) OFF: Depress and release the trigger
3) Only move the work piece after starting the
tool.
4) Once the safety brush worn, grinder is
designed to be turned off automatically.
5) Running the tool no loaded for at least 1
minute in a protection area when using the
new wheel for the first time.
6. TURNING GEAR BOX
1) Take off four bolts connecting gear box and
housing.
2) Turn the gear box to left 90 or right 90 in the
gear case wasn't unsheathe condition.(NOTE:
If the distance between gear box and housing
is more than 2mm, have repaired at your
nearest Authorized Service Center).
3) Reassembly the four bolts，after and screws
tight guarantees the bolt not slippery tooth.
APPLICATION
WARNING: To reduce the risk of injury,
electric shock and damage to the tool, before
any work check the utility lines electricity, gas or
water supply line are hidden in the work area.
WARNING: Firmly grasp primary hold part
of tool and side handle before starting.
1. GRINDING APPLICATION
1) When grinding, keep a 15°angle between
the wheel and the work piece, the best grinding
results can be achieved with part contact.
2) For avoid the work piece will not overly heat
up nor discolor and no ridges will be formed,
move the machine back and forth with
moderate pressure.
3) Never use cut-off wheel to grind work piece.
4) Always hold the tool properly so that sparks
and grinding dust fly away from the body.
WARNING: Sparks generated when
grinding metal. Take care that no combustible
material presented in the area of flying sparks.
7
Publicité
