Klarstein DeLorean Mode D'emploi page 31

Step 4: Hook the hood body:
• Open the panel.
• Remove the metal grease filter using the handles provided.
• The hood body can be hooked into two different places:
1 Either hook the hood body to the bracket (20).
2 Or hook the hood body to the (5 x 50) screws (10) at the points (2).
• Level the hood body itself.
Right
• From the inside of the hood body, fix the screws (10) to the wall plugs (1 1) at the
points (3).
• Fit the filter into the hood.
• Close the panel.
Installation with air exhaust system (ducted version)
Step 5: Connect the hood to the air exhaust system
• When installing the ducted version, connect the hood to the chimney using either a
flexible or rigid pipe 150 mm or 120 mm, the choice of which is left to the installer.
• To install a 120 mm air exhaust connection, insert the reducer flange (3) on the
hood body outlet.
• Fix the pipe (4) in position using sufficient pipe clamps (not supplied).
• Remove possible charcoal filters.
Wrong
EN
31