miniland baby warmy advanced Mode D'emploi page 20

ENGLISH
5. Now the display turns RED for 1 second and shows the
selected options.
If they are all correct, (and you have not programmed a time)
just wait 5 seconds without pressing any button until the
process starts automatically, the display will show the
remaining time the sterilization process ends.
If you have programmed in a time, the device will start
at this time.
However when you see the selected options on the RED screen if you want to
change them, please press the MODE button and you will go to the configuration
menu again (please go back to step 6).
6. When the sterilization process has been completed, you
will hear 5 beeps - this lets the user know that the process
has been completed.
The unit will turn off automatically after 15 minutes of waiting time. During this time
it is possible to switch the unit off immediately by pressing the MODE button for 3
seconds, or to start a new process pressing MODE button.
NOTE 1: During the sterilization process if there is not enough
water to complete the process, you will hear 5 beeps and the
display will flash in red, showing the water icon.
Please put 40ml of tap water into the heating chamber (add water up to the line in
the heating chamber) and press the MODE button once. The device will
automatically continue the process with the remaining time.
5.4. TROUBLESHOOTING
SYMPTOMS
1. The display is off
2. The screen is RED
and flashing with the
water symbol ( )
3. Other malfunctions
POSSIBLE CAUSE AND THINGS TO DO/CHECK
Please be sure you have plugged the device and
pressed ON button.
There is not enough water. Please put 40ml of tap water
into the heating chamber (add water up to the line in the
heating chamber) and press the MODE button.
Please contact the MINILAND technical service.
07:30
m:s
07:30
m:s
00:00
m:s
01:13
m:s