(Rlym-1 And Wrlym-1); Contacts And Operation - FireAngel RLYM-1 Mode D'emploi

• Check that the polarity of the auxiliary power supply
has been wired correctly and the power LED is on.
Please note: The maximum length of the lead for
the 12V DC supply should be no greater than 25m.
12–24V
EXTERNAL TRIGGER INPUT

(RLYM-1 and WRLYM-1)

Both RLYM-1 and WRLYM-1 relays are capable of
receiving an external trigger input from elsewhere
in a property such as an external control panel. The
external trigger input voltage is optional and can be
triggered by a 12-24V DC power supply.

CONTACTS AND OPERATION

Both RLYM-1 and WRLYM-1 models are equipped with
2 x NO/NC contacts rated at 250V AC - 5A / 30V DC - 5A
Each contact has both pulse and continuous modes of
operation, determined via dipswitch selection at the
point of install (3 & 4).
1
The Pulse output will switch back the relay contacts
to their original state after 5 seconds. The Continuous
output will continue to send a signal for as long as the
alarms are sounding on the network.
The RLYM-1 (only) has the additional option to turn
Relay B into a contact reporting only CO events,
selectable by a separate dipswitch (1).
ON
1
When this mode has been activated, an alarm from
any smoke and heat alarm on the network will
activate Relay A only, however an alert from any CO
alarm on the network will activate Relay B only.
12
ON ON
2 3 4 5
2 3 4 5