Mercatus WonderXPure 01 Notice D'utilisation page 13

User's Manual
Manal de Instruções
Manual de Instrucciones
How to clean WonderX Pure
11.4.
Ensure that WonderXPure is disconnected from the power source
In all circumstances we recommend using soft cloths or absorbent paper. Do not use steel wool, metal brushes or other abrasive
materials. Under any circumstances use chlorine-based solutions or other corrosive substances.
11.4.1. Lamps cleaning
 Carefully remove all lamps from the equipment under 11.1. How to remove lamps;
 Then moisten a clean, soft cloth with denatured alcohol and wipe the outer surface of the lamp; Do not use dirty cloths or those
with a hard texture that could damage the lamp. Do not use chlorine-based products or other corrosive solutions;
 To reinstall lamps follow the steps under 8.1. Lamps installation.
11.4.2. WonderX Pure surface cleaning
We recommend the following procedure:
 If the WonderXPure is dusty, use a soft, clean and dry cloth;
 If the WonderXPure has fingerprints, use absorbent paper (ex. kitchen towel) and apply with a glass cleaner product;
 In case of other type of dirt, choose to clean with a soft cloth, wet with hot soapy water and then wipe with a dry cloth.
11.4.3. Photocatalytic filter
 Carefully remove the lateral panel to access the photocatalytic filter;
 With a soft, clean and dry cloth gently clean the surface of the filter chamber to prevent dust from forming.
How to remove filters
11.5.
Ensure that WonderXPure is disconnected from the power source.
11.5.1. Pre-filter removal in WonderXPure 01
Lay down WonderXPure 01 onto its flat surface;

Place your finger in the triangular shape hole, displayed in figure 8;

Push back the triangular cap until it disconnects from the support structure;

Once disconnected the pre-filter is visible in the interior;

If needed perform necessary replacement;

Afterwards connect the triangular shape in the appropriate space and press in the center to

fit evenly.
11.5.2. Pre-filter removal in WonderXPure 02
Lay down WonderXPure 02 sideway;

On the bottom cap place two fingers on each hole;

Push back the cap until it disconnects from the support structure;

Once disconnected the pre-filter is visible in the interior;

If needed perform necessary cleaning or replacement;

Afterwards connect the cap in the appropriate space and press in the center to

fit evenly.
Notice d'Utilisation
Bedienungsanleitung
.
I0003-2021-MNS-MKT
Figure 8: pre-filter removal for WonderXPure 01.
Figure 8: pre-filter removal for WonderXPure 02.
13 / 44