Publicité
Les langues disponibles
Les langues disponibles
PREPARING TO TEST
1.
Be sure area around battery is well ventilated while battery is being
tested.
2.
Clean battery terminals. Be careful to keep corrosion from coming in
contact with eyes.
3.
Inspect the battery for cracked or broken case or cover. If battery is
damaged, do not use tester.
4.
If the battery is not sealed maintenance free, add distilled water
in each cell until battery acid reaches level specified by the
manufacturer. This helps purge excessive gas from cells. Do not
overfill.
5.
If necessary to remove battery from vehicle to test, always remove
ground terminal from battery first. Make sure all accessories in the
vehicle are off to ensure you do not cause any arcing.
OPERATION & USE
BEFORE TEST
1.
When testing a battery in a powersports vehicle, turn off the vehicle
and all accessory loads. The battery will hold surface charge if the
engine has been running for a while or after the battery has just been
charged. For a battery in a powersports vehicle, please turn on the
headlights for 30 seconds to remove the surface charge.
2.
Make sure the battery terminals are clean. Wire brush them if
necessary. Clamp the black load lead to the vehicle negative battery
terminal. Clamp the red load lead to the vehicle positive battery
terminal.
3.
Make sure you insert 4 AA batteries into the battery chamber located
on the back of the tester. Oxyride batteries are not recommended
because of the initial 1.7 Volt output. If the 1.5V battery runs out of
power, screen will show "REPLACE INTERNAL BATTERY" or "POWER
LOW". Replace those 4 AA batteries before starting the test.
- 3 -
Publicité
