Problem
E
H
won't run
Does not pick up debris
sensors do not activate 1.Unit is not in AUTO mode
E
Suction is not strong
Status indicator light blinking
Collection Bin Indicator Light is
ON
Debris at inlet before unit is
powered on
This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent
possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the
sustainable reuse of material resources. To return your used device, please use the return and collection systems or
contact the retailer where the product was purchased. They can take this product for environmental safe recycling.
This appliance is a dry pick-up, Canister type vacuum cleaner for household and indoor use. Also,it is a general purpose
vacuum cleaner, which can be used for both carpet and hard floor cleaning. It complies
with COMMISSION DELEGATED REGULATION (EU) No 665/2013 supplementing Directive 2010/30/EU of
the European Parliament and of the Council with regard to energy labeling of vacuum cleaners.
Plug & Technical Documentation
According to COMMISSION DELEGATED REGULATION (EU) No 665/2013 and No 666/2013
is used.
4 . The hard floor cleaning performance class: Class F.
5 . The dust re-emission class: Class F.
6 . he sound power level: 85 dB(A).
7. ests and measurements have been performed in accordance with EN 60312-1: 2013, EN 60704-2-1: 2001, EN
60335-2-2: 2010+A11:2012
8. he dust pick-up on carpet (dpuc) is 0.705, the dust pick-up on hard floor (dpuhf) is 0.970.
9. he energy consumption for carpet cleaning is 62,0 kWh/year.
10. he energy consumption for hard floor cleaning is 62,0 kWh/year.
TROUBLE SHOOTING
Possible cause
1.Not firmly plugged in 2.Unit is
in OFF position 3. Pre-Motor
Filter is not in position 4.No
power in wall plug 5.Blown
house fuse or tripped circuit
breaker
1.Dirt inlet is blocked 2.Container
is full 3.Debris may be too large
for inlet
1.Filters may be dirty
1.EyeVac sensors have been shut
off for 45 seconds which caused
power to the motor to be shut off
1.Collection bin is full
Correct Disposal of this product
Possible Solution
1.Plug in firmly 2.Depress Power Button to MAN or
AUTO position 3.Re-attach collection bin lid to top of
collection bin 4.Check house fuse or circuit breaker
5.Have a qualified licensed electrician replace house fuse
or reset circuit breaker
First. Depress Power Button to OFF position 1.Clean
path of inlet 2.Empty collection bin 3.Clear large
debris
1.Depress Power Button to AUTO position
1. Depress Power Button to the OFF position 2. Clean Pre-
Motor filter or Micro Exhaust filters when needed.
1. Depress Power Button to the OFF position
2. Check Pre-Motor filter and micro exhaust
filters to ensure they are clean.
1. Empty the Collection Bin; 2.Clean all filters
1.Depress Power Button to the MANUAL position
2.Activate unit manually