General Safety Practices; Basic Opera On Prac Ces - Skyfood SI-282HDE-1 Manuel D'instructions

4. GENERAL SAFETY PRACTICES

If any recommenda on is not applicable to your equipment, please ignore it.
The following safety instruc ons are addressed to both the operator of the machine as
well as the person in charge of maintenance.
The machine has to be delivered only in perfect condi ons of use by the Distributor to the
user. The user shall operate the machine only a er being well acquainted with the safety
procedures described in the present manual. READ THIS MANUAL WITH ATTENTION.

4.1 Basic Opera on Prac ces

4.1.1 Dangers
Some areas of the electric device have parts that are connected or have parts connected
to high voltage. These parts when touched may cause severe electrical shocks or even be
lethal.
Never touch manual commands such as switches, bu ons, turning keys and knobs with
your hands wearing wet clothes and/or wet shoes. By not following these instruc ons
operator could be exposed to severe electrical shocks or even to a lethal situa on.
4.1.2 Warnings
* The operator has to be well familiar with the posi on of ON/OFF Switch to make sure the
Switch is easy to be reached when necessary.
* Before any kind of maintenance, physically remove plug from the socket.
* Provide space for a comfortable opera on thus avoiding accidents.
* Water or oil spilled on the floor will turn it slippery and dangerous. Make sure the floor
is clean and dry.
* Before using any commands (switch, bu ons, lever), be sure it is the correct one. In case
of doubt, consult this manual.
* Never touch any manual commands (switch, bu ons, lever) unadvisedly.
* If any work is to be made by two or more persons, coordina on signs will have to be
given for each opera on step. Every step of the opera on shall be taken only if a sign has
been made and responded.
4.1.3 Advices
* In case of power shortage, immediately switch the machine off.
* Use recommended or equivalent lubricants, oils or greases.
16
IMPORTANT
Cheville de la Table Fixe
FIGURE 05
Re rer la Cheville la levant ver calment vers le haut de la Table Fixe, voir figure 05.
Table Fixe
Lever la par e frontale de la Table Fixe, voir figure 06, ver calment (voir la flèche) pour
relâcher l' entrave inférieure. Après, rer la Table Fixe en avant ( voir la flèche) pour sor r
complètement la Table, voir figure 07.
FIGURE 06
Lame
Tourner le Manipule du Calibreur de la Lame No 01 (Fig.01) dans le sense an -horaire
jusque la lame soit libre pour être re rée.
Employer des gants en maille d' acier pour prendre la Lame
Volant Supérieur
Après avoir re ré la Lame prendre fermement le Volant Supérieur No.05 (Fig.01) le
poussant vers le haut, ensuite poussez-le vers le devant de la scie.
Volant Inférieur
Re rez l' a ache No.01 (Fig.08) prenez fermement le Volant Inférieur et poussez-le en
avant, voir figure 09.
FIGURE 07
IMPORTANT
53