OUTER DIMENSIONS
In the drawings below, all the dimensions are displayed in mm.
Sufficient clearance around the hob is essential for a safe use of the hob. Check that there is sufficient clearance. The
minimum distance of the hob to a cooker hood should be at least 650 mm.
GAS CONNECTION
Caution!
The hob should be connected to a gas supply of the particular type of gas that the appliance is manufactured to
function with. Information about the type of gas that the hob has been adapted to by the factory is shown on the
rating label. The hob should be connected exclusively by an appropriately authorised fitter and only that person
has the right to adapt the hob to a different type of gas. .
Fitting guidelines
A fitter should:
• have a gas fitter's authorisation;
• be acquainted with the information included on the rating label of the hob about the type of gas to which the hob is
adapted; the information should be compared with the gas supply conditions at the place of installation;
• check:
- airing efficiency, that is effeciency of air exchange in the rooms;
- tightness of gas fitting connections;
- effectiveness of alle functional elements of the hob;
- if the electricity supply is adapted to function with a safety ground lead (zero).
• check the settings of the control knobs for the burners to ensure good functioning of the ingition and the
thermocouple.
Caution!
The hob may only be connected to a liquid gas cylinder of the existing gas supply by an authorised fitter, observing all safety
rules.
Connection with a flexible steel hose
If the hob is connected according to the class 1 specifications, only flexible metal hose can be used which meet the valid
national regulations. Gas feeding connector must be G ½" threaded coupling. Use only pipes and fittings that
meet the requirements of the valid standards. Maximum admissible length of the flexible hose is 2000 mm. Make sure the
connection is not touching any mobile elements which could damage the hose.
90
English
19
•