Celestron AstroMaster 70AZ Guide De Démarrage Rapide page 2

10
Loosen the set screw on the focuser. Remove the plastic cap
covering the end of the focuser.
13
To install the finderscope on the 70AZ, 90AZ, and 102AZ:
Loosen the two Philips-head screws on the side of the finderscope
and slide the clamp over the dovetail bracket. Secure the finderscope
in place by tightening the two Philips-head screws.
16
Remove the lens cap from the front of the telescope before you
begin observing.
F O R D ETA I L E D U S A G E I N F O R M ATI O N P L E A S E C O N S U LT YO U R O W N E R'S M A N U A L.
SOLAR WARNING: Never attempt to view the sun through any telescope without a proper solar filter.
11
Insert the diagonal into the focuser and tighten the set screw.
14
On/Off
Switch
Remove the small plastic tab under the battery cover by pulling it
straight out. For longer battery life be sure to turn off finderscope
when not in use.
17
You are now ready to start using your AstroMaster telescope.
12
Insert the chrome barrel of the 20mm eyepiece into the diagonal
and tighten the set screw.
15
Battery
Cover
To install the finderscope on the 80AZS:
screw on the dovetail mount on the top left of the focuser.
Slide the dovetail slider on the bottom of the finder bracket into
the dovetail mount on the focuser. Tighten the finger screw to
secure it in place.
Loosen the finger