Celestron AstroMaster 70AZ Guide De Démarrage Rapide

1
Your AstroMaster includes: Optical tube, StarPointer finderscope,
pre-assembled tripod with center leg brace and altazimuth mount
attached, two eyepieces, erect image diagonal, accessory tray, lens
cloth, battery, owner's manual, and a bonus Astronomy software.
4
All three legs should be the same length to provide a level platform
for the telescope.
7
Here is how the fully assembled tripod and mount should appear.
2
To set up the tripod, spread the legs outward until they are fully
extended. Extend each of the three tripod legs down 6-12".
5
To attach the accessory tray, line up notches and turn clockwise
until tray tabs lock into place with the tripod brackets.
8
Dovetail
Mount
Fastening
Screws
Next, slide telescope tube into the mount. Be sure to back out
fastening screws to allow enough clearance for the dovetail.
A Z T E L E S C O P E
MODELS #21061, 21082, 21063, 22065 (70AZ, 80AZS, 90AZ, 102AZ)
QUESTIONS OR PROBLEMS WITH SET-UP?
CONTACT CELESTRON TECHNICAL SUPPORT: 1(800) 421-9649
Q U I C K S E T - U P G U I D E
3
Use the three tightening screws located at the bottom of each leg
to secure the extended legs in place.
6
Properly assembled, the accessory tray should appear as
pictured above.
9
Center dovetail in the mount and tighten fastening screw. For
added security tighten the angled lock down screw next to the
fastening screw.
ENGLISH