Finish Printing - ATOMSTACK Cambrian Pro Manuel D'utilisation

a:Collect the model
After printing, you can insert a shovel into
the bottom of the model to remove the
model.

13.Finish printing

Support
Base
b:Removde the support base
Some of the models need to add support
base during the printing process. After
printing, remove the support base by hand
or with pliers.
*Extruder Cleaning
Now, congratulations on successfully
completing the first print! But we need to
develop a good habit. After each printing,
we need to clean the print extruder, which
can greatly extend the service life of your
equipment.