Step4: Cable Connectivity - ATOMSTACK Cambrian Pro Manuel D'utilisation

5.4 Step4: Cable connectivity

E285 extruder
Limitation
switch
motor at left
FFC cable
motor at right Limitation switch
Vertically insert
the cable into the
port of base
Power cable
S w i t c h
Z-axis motor
Z-axis parts connectivity
FFC connectivity connectivity
Instruction
1.Vertically insert the cable of Z-axis into the port of base
2.Horizontally insert the cable of Z-axis into the port of both motors
3.Vertically up insert the cable of limitation switch into the power
switch port
4.Insert the power cable.