Setup; Aligning Spray - Storch StraightGun Mode D'emploi

Setup

Connect Gun to Sprayer
Make sure sprayer is turned off and unplugged from
power source. Refer to your sprayer instruction manual for
priming and spray instructions.
1. Attach STORCH airless hose to sprayer fluid outlet.
2. Attach other end of hose to gun swivel. Use two
wrenches (one on the swivel and one on the hose), to
tighten all connections securely.
3. Refer to sprayer instruction manual for priming instruc-
tions.
If equipment has recently been operated, perform Pres-
sure Relief Procedure and engage trigger lock. To avoid
serious injury from skin injection, do not place your hand
in front of the spray tip when installing or removing the
spray tip.
Installing Tip and Tip Guard on Gun
To prevent spray tip leaks make certain spray tip and tip
guard are installed properly.
High-pressure spray is able to inject toxins into the body
and cause serious bodily injury. Do not stop leaks with
hand or rag.
1. Perform Pressure Relief Procedure.
2. Engage trigger lock
3. Verify spray tip and tip guard parts are assembled in
the order shown.
Reversible Spray Tip
Rubber
seal / metal
seat
Nozzle
holder
Union
nut
a. Use spray tip to align gasket and seal in the tip guard.
b. Spray tip must be pushed all the way into the tip guard.
Turn spray tip to push down.
c. Turn the arrow shaped handle on the spray tip forward
to the spray position.
4. Screw spray tip and tip guard assembly onto the gun
and tighten.

Aligning Spray

1. Perform Pressure Relief Procedure.
2. Loosen tip guard retaining nut.
3. Align tip guard horizontally to spray a horizontal pat-
tern.
4. Align tip guard vertically to spray a vertical pattern.
Horizontal
39
Vertical
Translation of the original instruction