Technical Data - Storch StraightGun Mode D'emploi

GB
Thank you
for purchasing a STORCH product. You have purchased a quality product.
If you would like to suggest an improvement, or experience a problem with your product, please do not hesitate to con-
tact us.
Please contact your field sales representative or, in urgent cases, contact us directly.
Yours sincerely,
STORCH Service Department
Tel.:
Fax:
Free service hotline:
Toll-free order hotline:
Toll-free order fax:
Table of contents
Technical Data
Warnings
Pressure Relief Procedure
Gun Trigger lock
Setup
Aligning Spray
Spraying
Clear Tip Clog
Drawings and Part Lists
Warranty

Technical data

Maximum working pressure
Fluid orifice size
Inlet size
Fluid tube, inside diameter
Warnings
Observe all warnings and safety instructions and the procedure for relieving pressure at the beginning of this operating
manual!
The following warnings are for the setup, use, earthing, maintenance, and repair of this equipment. The exclamation
point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When these sym-
bols appear in the body of this manual or on warning labels, refer back to these warnings again. Product-specific hazard
symbols and warnings not covered in this section may appear throughout the body of this manual where applicable.
Translation of the original instruction
+49 (0)2 02 . 49 20 - 112
+49 (0)2 02 . 49 20 - 111
0800 786 72 47
+49 800 7867244
+49 800 7867243
(only available in Germany)
280 bar
7/8"
1/2"
4.83 mm / 6.35 mm
(carbide)
Dimensions
Weight
Length
height
Weight
36
Page
36
37 - 38
38
38
39
39
40
40
41
42
958 g
289.56 mm
142.24 mm
30.48 mm