Pressure Relief Procedure; Gun Trigger Lock - Storch StraightGun Mode D'emploi

PRESSURIZED ALUMINIUM PARTS HAZARD
Use of fluids that are incompatible with aluminium in pressurized equipment can cause serious chemical reac-
tion and equipment rupture. Failure to follow this warning can result in death, serious injury, or property dama-
ge.
• Do not use 1,1,1-trichloroethane, methylene chloride, other halogenated hydrocarbon solvents or fluids conta-
ining such solvents.
• Do not use chlorine bleach.
• Many other fluids may contain chemicals that can react with aluminium. Contact your material supplier for
compatibility.
PERSONAL PROTECTIVE EQUIPMENT
Wear appropriate protective equipment when in the work area to help prevent serious injury, including eye
injury, hearing loss, inhalation of toxic fumes, and burns. This protective equipment includes but is not limited
to:
• Protective eyewear, and hearing protection.
• Respirators, protective clothing, and gloves as recommended by the fluid and solvent manufacturer.

Pressure Relief Procedure

This equipment stays pressurized untilpressure is manual-
ly relieved. To help prevent serious injury from pressuri-
zed fluid, such as skin injection or splashed fluid, follow
the Pressure Relief Procedure whenever sprayer is stop-
ped and before sprayer is cleaned or checked, and before
equipment is serviced.
1. Turn sprayer OFF.
2. Engage the trigger lock. Always engage the trigger lock
when sprayer is stopped to prevent the gun from being
triggered accidentally.
3. Turn pressure control knob to lowest setting.
4. Put circulation hose into a waste pail and turn circula-
tion switch in PRIME position (drain) to relieve pressure.
5. Hold the gun firmly to a pail. Point gun into pail.
Disengage the trigger lock and trigger the gun to relieve
pressure.
6. Engage the trigger lock.
7. If you suspect the spray tip or hose is clogged or that
pressure has not been fully relieved:
a. VERY SLOWLY loosen the tip guard retaining nut or
the hose end
coupling to relieve pressure gradually.
b. Loosen the nut or coupling completely.
c. Clear airless hose or spray tip obstruction. See Clear Tip
Clog.
Translation of the original instruction

Gun Trigger lock

To prevent injury when the gun is not inuse, always enga-
ge the gun's trigger lock if unit is being shut down or left
unattended.
Trigger lock engaged
38
Trigger lock disengaged