WAGNER HT2000 Mode D'emploi page 4

OPERATION
Before starting work it is advisable to test the
work surface for the ideal temperature to use.
The table below gives an indication of the
likely heat settings required but always start
with the low heat setting. All applications, with
the exception of removing paint from window
frames, can be performed without using a
nozzle, however for best results nozzles are
recommended.
Suggested Ratings
Low
Welding Plastic
Bending Plastic
Heat shrinking
plastic
Nozzles
The gun is supplied with 4 different shaped
nozzles, which can be used as follows.
Concentrator Nozzle
- G84
Directs a
●
concentrated heat
flow to the work
surface.
Ideal for removing
●
paint in awkward
corners, crevices,
mouldings, beading
or architraves.
Glass Protection
Nozzle - G89
Deflects the heat
●
away from glass
or other fragile
areas.
Ideal for windowsills,
●
ledges, frames, and
skirting boards.
Hook Nozzle - G87
Disperses the heat
●
flow evenly around
the whole work
surface.
Ideal for defrosting
●
frozen pipes,
soldering pipe work,
bending plastics or
heat shrinking
electrical parts.
High
Paint Stripping
Defrosting Pipes
Removes vinyl
floor tiles
Soldering
G84
Concentrator Nozzle
G89
Glass
Protection Nozzle
G87
Hook Nozzle
De flector Nozzle - G88
Directs a long, narrow
●
heat pattern to the
work surface.
Ideal for removing paint
●
or varnish from large,
flat surfaces such as
skirting boards, doors,
stairs, etc.
It should be used in
●
conjunction with a flat
scraper.
Vinyl tiles can be removed by softening
●
the tile and adhesive.
Removing Paint - General
Do not heat the paint for too long as this
will burn the paint, making it difficult to
remove.
1.Choose the required nozzle and fit
onto the heat outlet.
2.Hold the gun with nozzle approximately
50mm (2") from surface of paintwork.
3.Starting with the low heat setting, move
the gun slowly backwards and forwards
until the paint blisters and bubbles.
4.Immediately remove the paint with a
scraper or shavehook.
5.Aim to heat the paint just ahead of the
scraper so that you can develop a
continuous action.
Removing Paint from
Window Frames
WARNING – Glass can break easily when
heated.
1.Use the glass protection nozzle.
2.Ensure the nozzle is facing the correct
way to deflect heat away from the
glass before you switch on the heat
gun.
3.Rotate the gun/nozzle 90º as you move
to horizontal or vertical bead (take care it
could be hot!).
4.Paint can be removed by using a
shavehook and/or a soft, wire brush.
Maintenance
Always allow the machine to cool down (before
storing) and disconnect from the power supply.
The heat gun should be cleaned before being
stored away by wiping over with a clean damp
cloth. DO NOT USE CHEMICALS. Ensure
that the ventilation slots are not blocked.
Trouble Shooting
If a problem occurs always switch off the
unit immediately and disconnect from
power supply.
My unit fails to work?
If you are using an extension cable it must be
fully unwound and rated at 10 Amps. Refer to
'Thermal cut out' on page 3.
4
G88
Deflector Nozzle
TR
NL
RU
PL
DK
S