Starlyf Pressure Cooker Manuel D'utilisation page 8

8
New Zealand Consumer Guarantees Act
1993, both of which provide protection for
consumers. There is no express warranty for
this product in Australia or New Zealand. The
above paragraph refers to other countries.
This product complies with Low Voltage
Directive 2014/35/EC,
Compatibility
RoHS Directive 2011/65/EC restricting the
use of hazardous substances in electrical and
electronic equipment.
Problem
The lid does not close properly.
Air or steam is escaping from
underneath the lid.
Air or steam is escaping from the floating
valve.
The pressure regulator valve does not
rise when the device releases pressure.
The display shows E1.
The display shows E2.
The display shows E3.
The display shows E4.
Electromagnetic
Directive 2014/30/EC
Cause
The rubber seal is not in the correct
position.
The rubber seal is not in the correct
position.
There are traces of food in the rubber
seal.
The lid is not closed properly.
The pressure level inside the cooker is not
right and steam is being released through
the valve.
There are traces of food in the rubber
seal.
The rubber seal is broken.
There is not enough food and/or water
in the cooker.
The lid or pressure regulator valve is
faulty.
Short circuit.
Damaged sensor.
Temperature too high.
Pressure regulator broken.
Starlyf® Pressure Cooker
Mod: VHGSLCIND0034
Power: 800 W-1000W
Voltage: 220-240V~
Frequency: 50/60 Hz
TROUBLESHOOTING
- If your pressure cooker is not working
and properly, consult the following table. If the
problem persists, contact the customer
service department.
In the event of a breakdown, contact technical
support. Do not attempt to dismantle or repair
the product, since this is dangerous.
Solution
Make sure that the rubber seal is correctly
positioned under the lid.
Make sure that the rubber seal is correctly
positioned under the lid.
Make sure that the rubber seal is clean.
Make sure that the lid is closed properly.
Contact technical support.
Clean the rubber seal.
Replace the rubber seal. Contact technical
support.
Make sure that there is enough food and/
or water.
Contact technical support.
Contact technical support.
Contact technical support.
Wait until the cooker has cooled down.
Contact technical support.