Installation - brondell H2O+ Cypress H630 Manuel De L'utilisateur

INSTALLATION

Prior to installation.
a) Remove top cover with both hands.
b) Write filter replacement date on filter change sticker found on top
of each filter. Note: Carbon Block (HF-33) and Composite Plus (HF-31)
filters are 6 month filter life & Nanotrap (HF-32) filter is 1 year filter life.
Faucet Diverter Type (included)
1. Installing the faucet diverter.
a) Unscrew original aerator (faucet spout tip) from your
water faucet.
b) Connect diverter (with rubber washer) to water faucet by hand tightening
using any of the provided diverter adapters for best fit. If needed, use a
wrench (spanner) or pliers but be careful not to over tighten the connection.
Use Connection Tool for all "quick-connect" water tube
connections. To use: simply push down with the tool on the
Tips
connection point as you pull out tubing.
2. Installing the tubing.
a) Remove the water inlet plug on back of unit.
b) Connect one end of the 1/4" tubing (white)
to the water inlet on the water filter unit.
c) Connect other end of hose to faucet diverter.
Note: be sure to push tubing firmly all the way into the quick-connectors & use Connection
Tool as needed
Tips
3. First, turn on cold water faucet. Then, open the faucet diverter switch
to supply main water.
4. Press the button on top of the unit to dispense water (into your sink)
and let it run for 10 minutes to flush the system and activate the filters.
The initial flushed water contains carbon powder and air from
the filter. During flushing of filter, sound will be heard as carbon
powder and air is flushed out. This is not a malfunction, please
use the product as usual after flushing the filter.
Make sure to flush water continuously for at least 10 minutes
before initial use.
5