Publicité
Les langues disponibles
Les langues disponibles
CONNECT WIRING
4. Connect electrical wiring.
Run 120 VAC house wiring to installation location. Use proper
UL approved connector to secure house wiring to wiring plate.
Connect wires as shown in wiring diagrams.
SERVICE PARTS
Key No. Part No.
1
97016466 Housing
2
97016450 Duct Connector-6"
3
98010102 Wiring Plate
4
99170245 Screw, no. 8-18 x .375"
5
97016583 Wire Panel/Harness Assembly
6
10941286 Blower Assembly (QTXE050C)*
10941287 Blower Assembly (QTXE080C)*
10941266 Blower Assembly (QTXE090C)
10941267 Blower Assembly (QTXE110C)
10941268 Blower Assembly (QTXE150C)*
7
99140200 Grille Spring (2 req'd)
8
97016756 Grille Assembly (includes key no. 7)
9
99111293 Spacer (2 supplied)
10
97016909 Hanger Bars
*Assembly not shown.
Order service parts by "Part No." - not by "Key No."
SERVICE NOTE
To remove Blower Assembly:
Unplug motor (6).
Remove screw (4) from motor plate fl ange.
Find the single TAB on the motor plate (located next to the receptacle).
Push up near motor plate tab while pushing out on side of housing. Or insert a
straight-blade screwdriver into slot in housing (next to tab) and twist screwdriver.
Description
MODELS QTXE050C • QTXE080C
QTXE090C • QTXE110C • QTXE150C
INSTALL GRILLE
5. Finish ceiling.
Install ceiling material. Cut out around housing.
6. Attach grille
to housing.
Squeeze grille
springs and insert
them into slots on
each side of
housing.
BO0001
7. Push grille
against
ceiling.
BO0018
TAB
Page 4
30042415B
Publicité
