Sawing Without The Branch Support; Sawing With The Branch Support; Cleaning/Maintenance; Cleaning - Grizzly AAS 108 Lion Traduction De La Notice D'utilisation Originale

GB
Sawing without the
branch support
The branch support unit is not to be used
on wide diameter branches or wood.
1. Turn the machine on. Before switch-
ing the appliance on, ensure it is not
in contact with the workpiece.
2. Place the footplate (2) on the work-
piece.
3. Cut with a uniform forward motion.
You can saw horizontally, diagonally
or vertically.
4. After completion of the work, first re-
move the blade (1) from the saw cut
and then switch the appliance off.
Sawing with the branch
support
In the case of smaller diameter branches,
use the branch support.
1. Turn the machine on. Before switch-
ing the appliance on, ensure it is not
in contact with the workpiece.
2. Place the branch support (13) onto
the workpiece.
3. Move the saw downwards by applying
light pressure.

Cleaning/Maintenance

Remove the battery from the
device before carrying out any
work or transporting it. If the de-
vice is switched on accidentally,
there is a danger of injury.
84
Repair and servicing work not
described in this manual should
always be carried by our Service
Centre. Use only original parts.
Always wear protective gloves
when handling the saw blade in
order to avoid cutting yourself.
The following cleaning and servicing
should be done regularly. This will ensure
a long and reliable service life.

Cleaning

Do not spray the appliance with
water and do not immerse it in
water. Electric shock hazard!
• Keep clean the ventilation
slots ( 4), motor housing and han-
dles of the appliance. Use a damp
cloth or a brush.
Do not use cleaning agents or sol-
vents. You may otherwise irreparably
damage the appliance.
• Clean the saw blade holder (
with a brush or by blowing out with
compressed air. To do this, remove
the saw blade from the device.
16)