Charging The Battery; Removing/Inserting The Battery; Recharging The Battery - Grizzly AAS 108 Lion Traduction De La Notice D'utilisation Originale

• Avoid mechanical damage to
the charger. This can result in
internal short circuits.
• Do not operate the charger
on a combustible surface
(e.g. paper, textiles). Risk
of fire due to heating during
charging.
• If the power cable for this
equipment is damaged, it
must be replaced by the
manufacturer, a customer
service agent of the same or
a similarly qualified person
in order to prevent hazards.
• Do not charge non-recharge-
able batteries in the charger.
This could damage the appli-
ance.
• Remove the charging device
power adapter before start-
ing work with the device.
Do not use any extension
cables. The charging device
power adapter may only be
used indoors. Penetration of
water into the electrical appli-
ance increases the risk of elec-
tric shock.

Charging the battery

Charge the battery in a dry
room only. Prior to attaching the
charger, check that the battery's
outer surface is clean and dry.
There is a risk of injury due to
electric shock.
• Charge the battery before the first
time of use.
• Only use the charger from the pack-
age to charge the battery.
• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to
be replaced. Only use an OEM spare
battery available from our Customer
Service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information.
• The warranty excludes all defects
caused by improper handling.
Removing/inserting the
battery
1. To remove the battery (11) from
the device, press the release
button (10a) at the end of the
hand grip (9).
2. Open the cover (10) and remove
the battery (11).
3. To insert the battery (11) into the
device, push the battery along
the guides into the device.
4. Close the cover (10) again.

Recharging the battery

Charge the battery (
only the red LED of the charge in-
dicator (
the battery charge status").
1. Place the battery (
device.
2. Connect the charging cable con-
nector (14) with the charging
socket (12) to the underside of
the device.
11) when
5) is lit (see "Checking
11) into the
GB
81