Fabric Care Chart - Black+Decker BPWM16W Manuel D'instructions

ENGLISH
TROUBLESHOOTING & WARRANTY
ERROR CODE POSSIBLE CAUSE
E1 It takes over 30 minutes
to fill water but cannot
achieve its preset
water level.
E2 It takes over 10 minutes
to drain the water
but the washer is not
completely drained.
E3 The top lid is open.
E4 The washer runs out of
balance three times.
Page 32 Page 32
SOLUTIONS
Check troubleshooting (pg 32) for
washer not filling properly and
water leakage.
Check troubleshooting for Washer
will not drain water.
Close the lid and press the
ON/OFF button.
Redistribute the load.
TROUBLESHOOTING & WARRANTY

FABRIC CARE CHART

The following symbols provide garment care direction. The Clothing care labels
include symbols for washing, bleaching, drying and ironing, or dry cleaning when
necessary. The use of symbols ensures consistency among garment manufacturers
of domestic and imported items. Follow care label directions to maximize garment
life and reduce laundering problems.
Water Cycle Special Instructions
Normal
Permanent Press / Wrinkle
Resistant / Wrinkle Control
Gentle/Delicates
Heat Setting
Hand Wash
Water Temperature**
Hot
Warm
Cold
Bleach
Iron-Dry or
Any Bleach (when needed)
Steam Temperature
Only Non-Chlorine (color-safe)
Bleach (when needed)
Tumble Dry Cycle
Normal
Permanent Press / Wrinkle
Resistant / Wrinkle Control
Gentle / Delicates
** The number of dots represent appropriate wash water temperatures for various
items. The temperature range for Hot is 105°-125°F/41°-52°C, for Warm
85°-105°F/29°-41°C and for Cold 60°-85°F/16°-29°C.(Wash water temperature must
be a minimum of 60°F/16°C for detergent activation and effective cleaning.)The
clothes washer can
not ensure these temperatures because the actual temperature of the water entering
your washer depends on water heater settings and regional water supply
temperatures.
For example, cold water entering the home in the northern states during winter may
be 40°F/4°C which is too cold for effective cleaning. In this situation, you will need
to adjust the water temperature by selecting a warm setting, adding some hot water
to the MAX FILL line, or using your Washer's heating option, if available.
Warning Symbols for laundering
Line Dry/
Do Not Wash
Hang to Dry
Drip Dry Do Not Wring
Dry Flat Do Not Bleach
Do Not Tumble Dry
High No Steam (added to iron)
Medium Do Not Iron
Dryclean
Low
Any Heat Dry Clean
No Heat/Air Do Not Dry Clean
Line Dry/Hang to Dry
Drip Dry
High
Dry Flat
Medium
For machine-washable
wool. Loads should be
Low
under 8 pounds.
Page 33 Page 33
ENGLISH