Configuring Audio Ports - Toshiba Thunderbolt 3 Dock Manuel De L'utilisateur

Toshiba Thunderbolt™ 3 Dock
■
■

Configuring Audio Ports

You can play back or record audio either through the audio port of the dock
or the docked computer. However, you cannot use the audio ports on the
docked computer and on the dock at the same time.
Upon connection, the audio port on the dock might become enabled and
the audio ports on the computer disabled. When you undock the computer,
the audio ports on the computer are re-enabled automatically.
To change the default settings, you might need to adjust the audio settings
in Windows
If there is no audio device connected to the dock, the audio ports on the
■
NOTE
computer are enabled automatically.
Upon connection, to unplug and plug the Thunderbolt™ 3 USB Type-C™
■
cable again, you must close the running media playback application and
wait approximately 15-20 seconds for the new settings to take effect
before restarting the application.
Audio devices connected to the dock via the 3.5 mm audio jack appear
■
as Toshiba Thunderbolt™ 3 Dock Audio in Windows
EN-20
Settings
It allows you to configure the settings of this software.
Devices Check the related checkbox according to the
Connection detailed descriptions as you desired.
Thunderbolt™ Check the related checkbox according to the
Networking detailed descriptions as you desired.
Details It shows the version information of related
components.
Exit
You will exit the software by clicking this button.
®
manually, as described in this section.
® .
User's Manual