Axis P7701 Guide D'installation page 6

AXIS P7701 Installation Guide
Unit connectors
Network connector - RJ45 Ethernet connector. Supports Power over Ethernet (PoE). Using
shielded cables is recommended.
Power connector - 2-pin terminal block used for power input to the video decoder
with the supplied power adapter or an external power supply 8-20V DC, max. 8.3 W.
Function Pin number
GND 1
DC Power 2
Note:
Do not connect a power supply if the video decoder is connected to PoE.
Audio out - Audio output that can be connected to a public address (PA) system or an active
speaker with a built-in amplifier. A pair of headphones can also be attached. A stereo connector
must be used for the audio out.
DVI-I connector - The DVI-I connector has both analog and digital signals present simultaneously,
so the DVI connector can be used to connect to a monitor with either digital or analog input.
For digital input, the DVI-I connector can also be used to connect the AXIS P7701 to a monitor with
a DVI input, or to a monitor with a HDMI connector with the addition of a DVI-to-HDMI adapter.
The DVI connector can also be used with a DVI-to-VGA adapter to connect the AXIS P7701 to a
monitor with a VGA analog input.
RCA connector - Standard phono-type connector for composite video in PAL or NTSC. Allows
direct connection of an analog TV device.
Note:
If you connect the AXIS P7701 to a monitor using the RCA connector, you cannot use the DVI-I con-
nector at the same time to connect to a second monitor.
I/O terminal connector - The AXIS P7701 has one digital input that is used
for a video select switch, and it has an interface for auxiliary power and
GND. The fourth I/O pin is unused.
Description
Ground
Power input 8-20V DC, max 8.3W
Page 5
1 2
1 2 3 4