EarthWise SN70112 Guide D'utilisation Du Propriétaire page 9

This snow thrower is intended to be used to sweep snow
from sidewalks, steps, patios, decks and other hard flat
surfaces such as paved driveways. Use it only on hard,
flat surfaces free of sand, stone and debris, wires or any
other objects. The manufacturer is not liable for any
damage or injury resulting from misuse.
On/Off Switch (Fig. 4)
WARNING: The auger starts rotating immediately
after the snow thrower is switched on. Keep hands
and feet away from the auger.
To switch ON, hold the snow thrower firmly with two
hands, make sure the auger is not touching any surface
and press the Safety Lock Off Button (2) while squeezing
the On/Off trigger switch (3).
Once the snow thrower is started you can release the
Safety Lock Off Button.
To switch Off simply release the trigger.
Removing snow
WARNING: Before starting work, make sure that the area
to be cleared is free of stones, debris, wires and any
other objects.
Make sure all fasteners on the snow thrower (screws,
nuts, etc.) are fully tightened.
Check the auger for wear and tear at regular intervals.
Position the snow thrower so that snow will discharge in
a safe direction away from the operator and bystanders.
OPERATING
Clear snow often, before it gets too deep. It is best to
remove the snow as soon as possible after it falls.
Lift the auger up slightly before starting the snow thrower.
Switch on and tilt the snow thrower forward until the
scraper blade contacts the ground. Push the snow
thrower forward at a comfortable rate of speed, yet slow
enough to clear the path completely. The width and depth
of the snow determines your forward speed.
Direct the snow to the right or to the left by holding the
snow thrower at a slight angle. For the most efficient
snow removal throw the snow downwind and slightly
overlap each swath.
The snow thrower can remove up to 3-1/5" deep in one
pass. When clearing deeper drifts, hold the snow thrower
by the upper and lower handles and use a swinging or
sweeping motion. Shave off the top layer and make
multiple passes. (Fig. 5).
5
3-1/5"
9
Model SN70112
Correct
Incorrect