WARNING: California Proposition 65:
This product contains chemicals known to the
State of California to cause cancer, birth defects or
other reproductive harm.
WARNING: Some dust and debris created by this
tool could contain chemicals known to the State of
California to cause cancer, birth defects or other
reproductive harm. Some examples of these
chemicals are:
Do not abuse the cord. Never use the cord for
carrying, pulling or unplugging the charger. Keep
cord away from heat, oil, sharp edges or moving
parts. Damaged or entangled cords increase the
risk of electric shock.
Use of an attachment not recommended or sold by
the battery charger manufacturer may result in a
risk of fire, electric shock, or injury to persons.
Following this rule will reduce the risk of electric
shock, fire, or serious personal injury.
Do not service tiller with battery or switch key
installed.
Do not use the charger when the ambient
temperature is above 100°F (37.8°C) or below
32°F (0°C).
Do not operate charger with a damaged cord or
plug which could cause shorting and electric
shock. If damaged, replace the charger with an
identical charger from an authorized service
provider.
Do not operate charger if it has received a sharp
blow, been dropped or otherwise damaged in any
way. Take it to a qualified individual for electrical
check to determine if the charger is in good
working order.
Unplug charger from outlet before attempting any
maintenance or cleaning to reduce the risk of
electric shock.
Disconnect charger from the power supply when
not in use to prevent damage to the charger during
a power surge.
Risk of electric shock, Do not touch uninsulated
portion of output connector or uninsulated battery
terminal.
Do not expose charger to wet or damp conditions,
Water entering charger will increase the risk of
electric shock.
Make sure cord is located so that it will not be
stepped on, tripped over, come in contact with
sharp edges or moving parts or otherwise be
subjected to damage or stress. This will reduce the
risk of accidental falls, which could cause injury
and damage to the cord, which could result in
electric shock.
Keep cord and charger away from heat to prevent
damage to housing or internal parts.
Do not let gasoline, oils, petroleum-based
products, etc. come in contact with plastic parts.
They contain chemicals that can damage, weaken
or destroy plastic.
GENERAL SAFETY
-chemicals in fertilizer
-compounds in insecticides, herbicides and pesticides
-arsenic and chromium from chemically treated lumber
Your risk of exposure to these chemicals varies
depending on how often you do this type of work. To
reduce your exposure, work in a well ventilated area
and with approved safety equipment such as dust
masks that are specially designed to filter out
microscopic particles.
WARNING: Cancer and Reproductive Harm -
www.P65Warnings.ca.gov.
SAFETY RULES FOR CHARGER
An extension cord should not be used unless absolutely
necessary. Use of improper extension cord could result
in a risk of fire and electric shock. If extension cord
must be used, make sure:
a. That pins on plug of extension cord are the same
b. That extension cord is properly wired and in good
c. That wire size is large enough for AC ampere rating
Cord length (Feet) - 25'
Cord Size (AWG) -
Save these instructions. Refer to them frequently and
use them to instruct others who may use this product. If
you loan someone this tiller, loan them these
instructions also.
WARNING: Keep all connections dry and off the
ground. Do not touch plug with wet hands.
FCC WARNING:
Please note that changes or modifications to this
product not expressly approved by the party
responsible for compliance could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and
receiver.
-- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV
technician for help.
5
Model TC70040
number, size and shape as those of the plug on
charger
condition; and
of charger as specified below:
16
NOTE: AWG= American Wire Gauge
50'
100'
16
16