Start-Up - Jepson 9435 T3 Mode D'emploi

Additional safety precautions
for the Premium Super Dry Cutter
1. Always clamp the work piece securely.
2. Observe the rotation direction of the saw blade.
3. Ensure that the saw blade is always sharp, is unimpeded and runs without
vibration.
4. Lift the circular cold saw off the work piece before the safety switch is operated.
5. Before sawing, allow the motor to achieve full speed.
6. Operate the machine only if it is properly grounded.
7. Do not reach into the workspace with your hands while the machine is connected
to the socket.
8. Protect the machine against moisture.
9. Wear safety goggles, protective gloves, and ear protector.
10. To prevent unauthorized use, install a padlock through
the intended hole.

5. START-UP

After unpacking the machine, verify if the content is complete. Make sure to place
the machine on a solid and leveled surface. Loosen the locking bolt. Install the saw
blade according to the instructions in chapter 7.2,
"Replacing the Saw Blade". Before inserting the power supply plug into the socket,
make sure that it is a grounded socket. In the case you are using cable extensions,
you must make sure that they are also grounded.
The device must not
a humid environment.
be operated in
7